Copyright (c) Rotrix.co.za. All rights reserved.

Parts and Products

 

O-Ring Kits

13B 1986-1995 engines - All INTERNAL o-rings for these engines. The o-ring kit include Viton rotor oil seal rings and Teflon o-rings, except for the outer water jacket o-ring, which is made of the stock Mazda material

O-Ring Kit Part Quantity
Inner combustion o rings - Teflon encapsulated 4
Outer water jacket 4
Inner rotor oil seal 4
Outer rotor oil seal 4
Dowel pin o-ring 4
Rear stationary gear 1
Oil cross over ring 1
Injector diffuser o-ring 4
Front bolt o-ring 1
Front main seal 1
Rear main seal 1
Crank angle sensor o-ring 1
Tension bolt washers 18
Corner seal plug cord 1 strip

More information
RA Classic Seals

IC APEX SEALS & SPRINGS are suitable for use on all engines EXCEPT true high performance race engines. These seals offer 700% more bending strength and are 85% harder than the current after market competitors (Atkins and Hurley)

More information

2MM RA Super Seals

2MM RA SUPER SEALS are made of the same base material as RA CLASSIC SEALS. An additional process is done to make the seals even more resistant to high heat conditions, this processing raises the annealing temperature about 80% and gives the black colour. This gives an all important margin of safety in engines running high boost or a big shot of NOS.

We will add the RACING SPRINGS with this set of seals.

More information

3MM RA Super Seals

3MM RA SUPER SEALS are made of the same base material as RA CLASSIC SEALS. An additional process is done to make the seals even more resistant to high heat conditions, this processing raises the annealing temperature about 80% and gives the black colour. This gives an all important margin of safety in engines running high boost or a big shot of NOS.

3MM SETS USE 3MM Mazda factory SPRINGS.

More information
Thermal Pellet

It This part fits all 13B (including Renesis) engines. This REPLACES the stock thermal pellet. allows the oil to cool the rotors ALL THE TIME and maintains oil pressure during warm up. Using this pellet helps to prevent damage to the engine that may be caused by the stock pellet (which does NOT allow oil to cool the rotors until the engine reaches a certain temperature.)

More information
E-Shaft Oil Jets

These are original Mazda oil jets for use in HIGH PERFORMANCE CARS. This is a Mazda Performance part that is very hard to find. They do NOT use the ball and spring/check valves, so they are not suggested for cars that drive around the city and idle a lot.

More information
Oil Seal Springs

These are MAZDA PERFORMANCE PARTS and are difficult to find. They are NOT available from your local Mazda dealer. The oil seal springs are for 1979-1995 engines. Set is for a two rotor engine.

More information 		Price to be announced


Engine Bearings

ENGINE BEARINGS ON REQUEST. 		Price to be announced
Series 4 & 5 Blank Off Plates
Series 6 Blank Off Plates
Cosmo Blank Off Plates

Racing Lightweight Flywheel
Round Stainless Steel Silencer

Size to order, silencer wool/wadding replaceable.
Rotary Stainless Steel Silencer

Size to order, silencer wool/wadding replaceable.